How do I set alarms on WxGoos Series I?
For each sensor there is a Low Trip, High trip and Alarm State. Use the low and high trips to set the acceptable range for the sensor. If the current value of the sensor goes below the Low Trip or higher than the High Trip, or the device is unplugged the alarm is considered tripped. When the value goes back into the acceptable range or the device is reattached, the alarm is cleared. To control how you will be notified of alarm trips and clears use the Alarm State drop-down. The choices are Email, SNMP trap, Buzzer( if the unit has one), or a combination of these. One notification is sent when the alarm is tripped and another notification is sent when the alarm clears. Set the alarm state to Disabled if you do not want to set an alarm for a sensor. Make sure to click Save Changes after adjusting the alarm settings.
