Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

How do I reset the dynamometer when it says “dyne not found” or “dyne communication error”?

April 26, 2017dynamometer reset

0

Posted

How do I reset the dynamometer when it says “dyne not found” or “dyne communication error”?

1 Answer

0

Posted

Perform the following procedure, in the exact order shown below, to reset the dynamometer. • Turn off the 240 VAC to the dynamometer. • Turn off the 120 VAC to the dynamometer. (Clayton only) • Turn off power to the Emission Analyzer. • Wait at least three (3) minutes. (This would be a good time to check the dyne interface cable and connections between the dynamometer and the emission analyzer.) • Turn on the 240 VAC to the dynamometer. • Turn on the 120 VAC to the dynamometer. (Clayton only) Turn on power to the Emission Analyzer.