Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

How do I replace the LED third brake light on a 2001 Chevrolet S-10 Blazer?

April 26, 2017Blazer Brake chevrolet LED light replace s-10

0

Posted

How do I replace the LED third brake light on a 2001 Chevrolet S-10 Blazer?

1 Answer

0

Posted

there are 2 set screws in the ends of the light, remove these 2 screws, open hatch and look where the wire runs pull rubber grommet seal and disconnect wire at connector, careful that other end does not pull back in, i tie string on it before disconnecting so i cant loose connector inside. then close hatch and carefully pull up 3rd light (it is held by double sided sticky tape) clean surface with wd40 and then windex to remove goo from old tape put wire through on new 3rd light and connect wires, peal covers off sticky tape align press down and replace screws.