How do I perform a vehicle ID on a Medium Duty truck when using IDS?
Because the ECM communicates on a different data link, IDS cannot ID the vehicle when it’s connected to the 16-pin connector. To properly ID the vehicle, follow these steps: No Comms Method: With the IDS software running, connect the diagnostic tester to the 16-pin connector using the VCM and related cables. • From the vehicle ID screen select Start New Session and then click the blue tick. • Click the blue tick at the next screen. • IDS will now attempt to establish communication with the PCM. • After the communication attempt fails you will be asked if you would like to reattempt a connection. Click the “NO” button and then follow the on screen directions for cycling the ignition switch. • You will now see a list of vehicles to choose from which will allow you to manually ID the vehicle. Select either F-Series or LCF and cascade through the appropriate menus. Manual Vehicle Entry Method: It’s also possible to ID the vehicle from the vehicle ID screen by selecting Manual Vehicle Entry
