How do I know if the code being taken correctly by the reader while programming the Omni reader? What else do I need to know when programming the reader through keyboard entry?
The reader should sound two slow beeps after all of the code commands except for the ‘save & exit setup mode’ commands. For the ‘save & Exit Setup Mode’command codes, which should always end with the letter ‘Z’ the reader will sound 4 slow beeps when Enter key is pressed. The reader will sound 4 quick beeps to indicate any of the following errors: 1) If the command code entered is invalid 2) If the code has been corrected by using the Backspace key during typing 3) If a number key from the numeric keypad is used for the numbers in the code To correct above problems, 1) Always, verify the code in the manual to ensure that it is a valid code. 2) Notice that the configure code is case sensitive. Type the code in slowly & correctly. If there is a typo, press the Enter key, and re-type the code correctly. (Do NOT use the Backspace key or any other key to correct the error). 3) Make sure to use the number keys above the main Alpha-keypad. Do Not use the number keys on the number keypad locat
Related Questions
- I purchased a new workstation and cannot connect the ASP portable bar code reader to the keyboard PS2 port. How do I connect the ASP Portable barcode reader to a PS2 type keyboard?
- If a provider enters the HCPCS Level I, II or III code, units and/or NDC correctly, but does not enter the unit of measurement correctly, will that line item be denied?
- Can we make Bar Code Reader application in asp.net technology?
