How do I install the Plastic Speed Reducer (Face Plate)?
Remove all attachments from the machine and unscrew knobs at end of latching arms. Carefully peel off “TWIN GEAR” sticker ( for Green Power Juicer only). Unscrew 2 small screws in each latching arm, be careful not to lose any (for Green Power Juicer only). Unscrew 3 or 4 screws in face place. Pull out old face plate. (Please observe how the latching arms are positioned in the motor front plate and the flat side of the latching arms face outside) Remove bushing (white and orange color) from old face plate by pushing it out of the face plate.(this is the part that the “male” gear fits into) Position bushing onto motor. Line up the bushing with the appropriate groove. Check that all seals are installed? Clean up motor shaft if necessary. Slightly grease drive shaft. Install face plate by following above instructions in reverse order.
