How do I install the Hyundai Tiburon headlight to my vehicle?
Installation – 2003 Hyundai Tiburon Installing the HID conversion kit is very easy. Decent kits are plug and play. The Xenon Depot kit I purchased was very straightforward to install. Simply take out the three bolts that hold the headlight assembly and set it aside. I chose to mount the ballasts under the lights (see photo right) to keep them concealed as well as out of the hot engine bay. Judging by its cleanliness, this location does not get wet from rain or water spray. The ballasts and the wiring harnesses are sealed so a little water wouldn’t hurt them anyway. Then find a location to mount the relay. I mounted them to existing bolts on the engine compartment sidewall, just behind the headlights (see photo). Run the fused 12V leads to the battery, and affix the ground ring terminals to chassis ground. Use a hole saw or spade bit (in this case, 1.0″ dia) to drill a hole in the center of the round bulb cover to accept the rubber wiring grommet. The cover I’m referring to is the seale
