How do I install SLiME into a Presta valve?
SLiME’ing a PRESTA tube: 1) Remove the safety seal from the slime bottle and screw the tapered funnel top back into place on the bottle. 2) Screw the retaining nut that sits on the sealing post of the Presta valve entirely off the end of the post. This will allow the post to fall through the valve into the tube. Make sure you catch the post inside the tube and hold it pinched right there so when you’re finished you can easily drop it right back into the valve. You will probably need a small pair of pliers to get the nut off the valve. Do not loose the nut. 3) If the tube is new, then blow a little bit of air through the valve into the tube using your mouth. This will make it easier to fill the tube with Slime. 4) Insert the end of the Presta valve into the tapered funnel opening of the top of the bottle and screw the bottle down until the end of the taper fits snugly against the wider part of the Presta valve and the hole of the valve is entirely inside the top of the bottle. This will
