How do I install a SIMM Module in an HP 5si, 5si MX, and 5si HM printer?
SIMM boards can be damaged by small amounts of static electricity. When handling the SIMM board exercise care and, if possible, wear an antistatic, wrist strap connected to the metal frame of the printer (or to your antistatic system). During installation, to prevent generation of static electricity, avoid moving about the work area. To avoid damaging the printer or SIMM module, follow these steps: • In this order, switch the printer power OFF, unplug the power cord, and disconnect any attached cables. • Loosen (but do not remove) the two captive thumb screws (top and bottom). • Grasp -the screws and pull the printer controller board out of the printer. Do not touch any component on the board. Place the board on a flat, nonconductive surface. (For case of replacement, note how the board fits into slots in the printer.) • Remove the SIMM board from the shipping package. Do not touch any component on the SIMM board. Hold the board with your forefingers on the side edges and your thumbs a
