How do I install a SIMM Module in an HP 5 and HP 5M printer?
SIMM boards can be damaged by small amounts of static electricity. Wear an antistatic wrist strap (or frequently touch the surface of the antistatic package or bare metal on the printer) when handling the board, and before installing or removing it. • Before you begin these steps, turn the printer off and unplug the power cord. • Rotate the printer so that you have easy access to the right and back sides of the printer. • Loosen the captive screw in the upper left corner of the back panel with a Phillips #2 screwdriver. The screw does not need to be completely removed from the printer. • Slide the right side panel towards the back of the printer (approximately an inch (25 mm)). • The panel should now easily open, exposing the SIMM door. • Loosen the captive screw holding the SIMM door with a Phillips #2 screwdriver. Open the SIMM door. • Note the four SIMM slots (a PostScript SIMM will already be installed in a slot in the HP LaserJet 5M). For easiest installation, fill the slots from
