How do I handle inexplicable error messages during automatic dimensioning?
Certain circuits are not included in the automatic dimensioning cycle, although the corresponding operating modes for supply were set. I get unexplicable error messages which canot be eliminated. When I call up the quick view for the calculation results (“Tooltip”) “Circuit was never closed or supplied” is displayed. This occurs with circuits which I cannot even connect into, or disconnect from supply in the Operating modes dialog.These circuits are internally disconnected, although they are designed as non-switchable in the Operating modes dialog. Proceed as follows in order to restore the calculation: For individual circuits (loads, directional couplings), delete these circuits and add them again. If larger subnetworks are affected, please create a new infeed (this is only possible with SIMARIS design 5.0 professional) and then move the affected subnetwork to the infeed’s LVMD. Then redimension this new network automatically and move the affected subnetwork back to its original posit
