How do I connect the trunk port and/or correct its speed and duplex configuration?
Complete these steps • Issue the set port speed [module_#]/[port_#] [speed] command, where module_# and port_# are the module and port numbers for the trunk port in question and speed is the desired port speed. The port speed must either be 100 or auto, when in doubt use 100. • Issue the set port duplex [module_#]/[port_#] [dup_type] command, where module_# and port_# are the module and port numbers for the trunk port in question and dup_type is the desired duplex setting. The duplex setting must either be full or half.
