How do I configure the set-points to use for a heat source calibration?
A. Because a minimum number of set-points are required by MET/TEMP II to calibrate a heat source, MET/TEMP II requires you to open a pre-defined set-point configuration file. One configuration file for each heat source that MET/TEMP II can calibrate is provided with MET/TEMP II. These files are installed to the [C:\MetTemp2]\Config\CalFiles folder. These files contain recommended settings for calibrating heat sources, They are marked as read-only and should not be modified. You should use these files as a starting point for creating your own set-point configuration files. Open the appropriate set-point configuration file. If needed, modify the settings and save the new settings to a new set-point configuration file with a new filename.
