How do I configure the Cisco 675 for bridge mode with bridging management enabled?
A. When the Cisco 675 operates in bridge mode, it behaves like a wire connecting a local PC directly to a service provider’s network. To run applications that require IP communication, such as ping, enable bridging management. To enable bridging management, log in to the console port of the Cisco 675 (see How do I connect to the Cisco 675 through the management port?). Perform these steps: • Type set bridging rfc1483 enabled. Press Enter. • Type set bridging management enabled. Press Enter. • Using an eth0 address in the same subnet as the one assigned for the PC, type set int eth0 address
