Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

How do I configure an HP router and HP 28674B Remote Bridge RB to communicate over a WAN?

April 26, 2017bridge Communicate configure HP RB remote Router WAN

0

Posted

How do I configure an HP router and HP 28674B Remote Bridge RB to communicate over a WAN?

1 Answer

0

Posted

In the router’s Configuration Editor, set the following values in the WAN CIRCUITS screen: Quality of Service:LLC 2 (reliable) Circuit Type:HP Point To PointRetry Counter (N2):4 Retry Timer (T1):3Connect Retries:0Link Idle Timer (T3):10 Modulus:8Window Size:7Point to Point Address:Auto or DCE Minimum Frame Spacing:2Max Link Latency (ms) (0=none):0 Compression:No CompressionRemote Signal & sense:Inactive Data Link Layer protocol:StandardNotes: • The Retry Counter value must be the same on both the router and the bridge. The default value for the HP Remote Bridge RB is 4. • The Point to Point Address may be set to either Auto or DCE on the router. If set to DCE on the router, the HP Remote Bridge RB must be configured to DTE.