how do i bleed the front brake line?
Answer Hi C Turner, Review the following informaion files. If the lever does not develop pressure, maybe the master cylinder needs a new seal kit. Respectfully, Mark Shively Brake/Clutch Bleeding 101 By Mark Shively Use high quality DOT 4 brake fluid (or preferred type) from a sealed container. Remove the old fluid from the master cylinder reservoir. Use a cooking type squeeze bulb baster to remove the bulk of the fluid. Use a paper towel to remove any remaining fluid. Top off the empty reservoir. Top them off periodically during this procedure. Do not spill any fluid on your bike because it may damage the paint. The front brake reservoir tends to spit fluid out the top during this process so make sure you place a bunch of rags, old blankets, or towels over the fuel tank. You can make a bleeder drain container fairly easily by taking a plastic container with a screw on lid. Put a hole in the container lid just large enough to get the hose through. Put a short section of hose on the ble
