How do I best put The Roscoby Riser Cam on my bow so that it stays tight?
Before attaching the camera to your bow, be sure to have a fresh SD card and batteries installed. Make sure the End Cap is properly attached to the Main Camera Housing. Begin by tightening the Jam Nut into the Rubber Isolator. This compresses the Isolator and allows the user the opportunity to adjust the Jam Nut for fine tuning the camera position on the bow. Each bow is unique and will require a bit of fit and feel testing to get the camera properly oriented on the bow. Thread the Mounting Stud into the Stabilizer bushing on the bow until it comes tight against the Riser. It is unlikely that the camera will be properly oriented on your bow. This is where the Jam Nut needs to be adjusted slightly (loosened or tightened) and the camera re-tightened back to the Riser. It may take a few attempts to adjust the Jam Nut just enough to bring the camera to almost vertical alignment on your bow. With the camera almost vertical, use ONLY the Jam Nut to firmly tighten and secure the camera into p
