How do I adjust front torsion bars on a 1995 K2500 diesel?
How do I adjust front torsion bars on a 1995 K2500 diesel? –> Reply With Quote –> 03-26-2010 08:14 PM #2 dhjunkie View Profile View Forum Posts Private Message View Articles Registered User Join Date Jan 2010 Location Commifornia Posts 98 It’s not that hard. 1st take a measurement from the center of the front hub to the lower edge of the fender well (above the tire). this will give you a baseline measurement. 2. Jack up the truck at the frame rails taking the weight off the front tires and suspension. 3. Under the truck there is a crossmember that houses the adjusting keys for the torsion bars. At each end of these keys is a bolt. This bolt controls the ride height of the vehicle. Tightening this bolt will raise the vehicle and lossening it will lower it. 4. Take a mental and written note on where this bolt is from factory. Tighten this bolt in 1/4″ increments equally on each side. 5. Take vehicle off jack stands. Jounce the front end of truck rigorously to settle the suspension and
