How can I trick EQ4 into not printing foundation patterns across two pages?
• In Print, Foundation Patterns, Sections tab, click on Start Over. You can click on patches and regroup them for foundation units. Each time you click on patches that should be grouped into one unit, click on the Group button. Do this for all the units in the block except the one that wants to overlap onto the next page. Do not click on the patches for this unit at all. • Click on Preview and you will see all the units you did group ready to print out except the one that was errant. • Print. • Now go back and do the grouping again, only backwards. Do only the unit that you didn’t print the first time through. In Preview, only that unit will show up, and you can print that out.
Related Questions
- I would like to print a test printing of my layout pages at a smaller scale than my final printing. How can I do this easily, without changing all my settings in the Page Setup dialog?
- When printing the document, the fonts don look right or the text is misaligned on the printed pages. How do I print the document properly?
- How can I save paper by printing multiple pages onto a single page, and/or print on both sides?
