How can I tell if my wallbox is sending pulses ?
Easy, place the WP200e into “wallbox pulse view”. Press and hold the STOP key on your remote control until the LED on your WP200e stops blinking, then press and hold the PGM or PROGRAM key until the LED starts blinking again. Make different selections on the wallbox while watching the LED. You should see some blinks, a pause, then more blinks. If you didn’t see any blinking, use a piece of wire and momentarily connect the COMMON to the SIGNAL on your wallbox, the LED should light which would indicate a problem with the wallbox. If the LED still didn’t light, check your power and wallbox connections. You can verify the WP200e operation by placing a 9-volt battery to the 2-conductor zipcord wires, the LED should light.
