How can I stop my remote control from switching back to the receiver mode after I’ve selected another device?
You have encountered a feature known as Device Priority, in which the remote control gives priority to the control codes for the receiver over other devices. As you may be aware, pressing the input selector for a particular device switches the remote to the control codes for that device. Your remote was programmed at the factory to keep those codes active for only six seconds after the last button press, and then return control to the receiver codes. However, you may wish to either extend that time period to twelve seconds, or disable the priority altogether, in which case the remote would always control the last-used device and you would have to remember to press the selector for the receiver before using the remote for receiver functions. To change the device priority, press and hold the Program button for three seconds, until the red light under the Set Button is illuminated. Press the Set Button to access the remote’s Main menu. Use the up and down arrow controls to scroll through
Related Questions
- Single channel switching receiver (NASA) and full time dual channel receivers (EasyAIS and Comar). What are the differences between these models?
- How can I stop my remote control from switching back to the receiver mode after I’ve selected another device?
- Can I use my dual-tuner receiver in either Single Mode or Dual Mode to send content to my Archos device?
