How can I shut off the ethernet port without loosing management of a SU-x unit?
A. On the SU that you want to deny customer access to, turn on IP filtering, and simply filter out the address or subnet that the customer is using. Configure the User Defined IP Address table to an IP range that is not in the range or subnet that the customer is using. Q. My AU started acting up tonight. I noticed that the unit wasnt responding to SNMP polls, so I went to check on it. I reset it and it lost all its configuration information. No biggy right? Well, I put all the info back in, IP, subnet, ESSID, etc. I hooked it back up to see if it would work again, and it didnt. And it didnt respond to a telnet request. I pinged it, and it replied fine. So I hooked the monitor cable up and began a serial session into the unit, and I noticed that the country code changed. What can I do? A. When configuration changes seemingly by itself, this indicates there is a hardware problem with the unit. If warranty still applies, contact Alvarion tech support to RMA the unit. If the unit is out o
Related Questions
- Is the management modules ethernet port the same interface for both management modules, or is each management modules ethernet port configured separately?
- Can I use an LS1010 ATM Switch in order to route traffic between the Management Ethernet Port and an ATM PVC?
- How can I shut off the ethernet port without loosing management of a SU-x unit?
