Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

How can I set the IP address in my WinPLC with Windows Vista?

January 20, 2020ip address Windows Vista winplc

0

Posted McLova edited answer January 20, 2020

How can I set the IP address in my WinPLC with Windows Vista?

3 Answers

0

McLova 0 Posted McLova edited answer January 20, 2020

I’ve updated my Windows and have a few problems. I can’t set the IP address in my WinPLC!((An also have a problem with microphone, it’s not detected in the system and Microsoft Edge doesn’t start and reset doesn’t help. Maybe, I have a problem with drivers?? I’ve updated all the necessary drivers before, but it’s was a long time ago. Probably I need to do it again

0

TryToKi55 Posted

Thanks for the information. I had problems with findind my IP adress so if someone will need it too, go to https://www.showmyip.com. There you’ll see the IP and the location. But Windows 7 Ultimate supports the IPX protocol?

0

Posted

Windows Vista does not support the IPX protocol. You cannot use IPX to reset the address. There is a workaround. 1. Insure that you have turned off your PC’s firewalls 2. Power down the rack containing the WinPLC. 3. Remove the WinPLC and set dipswitch #7 (last to left) ON 4. Place the WinPLC back in the rack and apply power. The RUN and POWER LEDs will be flashing. 5. Use Netedit3 and scan network using TCP/IP 6. Double click on the WinPLC and change the IP address. 7. Power down the rack containing the WinPLC. 8. Return dipswitch #7 to OFF. 9. Place WinPLC back in the rack and apply power. The RUN and POWER LEDs will not be flashing.