How can I modify the Spine Label report to adjust the labels to align properly on my printer or change the font size?
If the spine labels do not print properly with your laser printer in Auto Librarian Library Server V.4 (for example: call numbers run off the labels after the first few labels printing left to right or if the font size is too small) modify the report using the following directions: Read entire directions first, then proceed IMPORTANT: Make a copy of the original report spinelabel.srw (rename it spinelabeloriginal.srw so that the original file can be replaced if needed in case another printer is used. Click Reports, Custom, Custom Report Wizard. Open File – C drive, Auto Librarian, spinelabel.srw At the Layout Page tab click on the design tool icon (with designers triangle). Note that font size is also located on the Layout Page tab – change the font size here. Click Report Setup button. Label file tab. Look at the dimensions of the label. Adjust the Horizontal Gap – this is the gap between the labels left to right – (the current setting is .125). Changing this setting just a bit will i
Related Questions
- I am a label printer; how can I know if the labels I provide a customer are required to be Recognized under the Marking & Labeling Systems program?
- How can I modify the Spine Label report to adjust the labels to align properly on my printer or change the font size?
- How do I print labels to a label printer, commonly called thermal printer, from the AS/400?
