How can I get my 1″ SCWD to work with Flow Accelerators, such as Eductors, Penductors, etc.?
When using Flow Accelerators you drastically reduce the volume of water going through the SCWD because the Flow Accelerators outlets are approximately inch in diameter. By installing a Flow Extender in the SCWD you will provide a more focused flow of water to the Drive allowing it to turn. Under higher pressure conditions, you may have to sleeve the Flow Extender to reduce its inside diameter. To do this, you can insert a piece of vinyl tubing or a smaller diameter pipe in the Flow Extender to provide an even more concentrated flow to the Impeller.
Related Questions
- When I use my SCWD, I notice that the outlets dont completely restrict the flow of water when in the closed position. Is there something wrong with my SCWD?
- D Accelerators I have a 3D-accelerator card that supports 3DFX Glide, PowerVR, Direct3D or OpenGL. How can I switch Unreal into the correct mode for my card?
- How can I get my 1" SCWD to work with Flow Accelerators, such as Eductors, Penductors, etc.?
