Does Software Management update the configuration file on Cisco Catalyst 5500/5000 devices during the software upgrade?
A. Software Management updates the configuration file on Catalyst 5500/5000 devices only when the device has a Supervisor Engine III card. Software Management updates the boot system commands and the config register value if necessary. For Supervisor Engine I and II and other module upgrades, Software Management does not update the configuration file on the device. Instead, Software Management uses CISCO-STACK-MIB and TFTP to download the configuration file. Before Software Management changes the configuration file on the device, Software Management backs up the file to the Job Schedule directory. The example below illustrates the Software Management update of the configuration file. Assume that a Supervisor Engine III card runs 3.1(1) software. Also, assume that the software image file is on slot0 with the name cat5000-sup3.3-1-1.bin. The configuration file boot system commands before the upgrade are: set boot system flash slot0:cat5000-sup3.3-1-1.bin Software Management has upgraded
Related Questions
- Does Software Management update the configuration file on Cisco Catalyst 5500/5000 devices during the software upgrade?
- Does SWIM update the configuration file on Cisco Catalyst 5500/5000 devices during the software upgrade?
- Does SWIM update the configuration file on Cisco Catalyst 5500/5000 devices during software upgrade?
