Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

Does IG2&#153 High-Flow-Area mesh itself get clogged?

April 26, 2017clogged high-flow-area ig2™ mesh

0

Posted

Does IG2&#153 High-Flow-Area mesh itself get clogged?

1 Answer

0

Posted

There are some chances. Some very narrow particles may slightly stick into larger IG2&#153 High-Flow-Area holes. This increases the chance to get enough of stocked in the mesh particles to block the whole area. The worst what weve seen so far are very short (approximately 1″ long) pine needles falling in pairs. We have such situation on at least one of our projects (installed in spring of 2008) with lots of such needles, and no problems so far. In such situation, wed suggest to even further increase mesh angle, to minimize chances for anything to stay on it.