Does anyone know how to program a keyless entry remote for a 1996 Chevy Lumina?
I’m hoping this is the Lumina sedan, not the van. In the trunk, on the passenger side, there should be a wire with a plastic connector, not hooked to anything. It’s up on the side of trunk. Below that, on the floor of the trunk, there’s a piece of metal with a square cut out of the center. You need to put a jumper wire to those two things; from the connector to the metal. Then: 1. (this is what you just did) Jumper the Keyless Programming Connector to ground (all power door locks will lock and unlock). 2. Operate Transmitter by pressing a single button once (all power door locks will again lock and unlock). 3. To program for a second Portable Transmitter, operate Transmitter 2 by pressing a single button once. In order for programming to be complete, wait for the locks to fully cycle. 4. Disconnect Keyless Programming Connector Jumper after locks have finished cycling. 5. Verify that the Transmitter(s) operate Door Locks and Rear Compartment Lid Release.
