Do you have an interface board for the superpro 40 pin programmer, and if so at what cost?
We do not carry the ISA Interface card for Superpro anymore. The card is very old and it will work with very slow PC (AT/386/486) and under DOS only. Please consider trading in your programmer and upgrading to one of our USB interfaced programmers. Q: We have toshiba m-100 pc w/o parallel port availability. Can I use USB to parallel cable to use superpro z model if not what is the solution A: We don’t support USB to Parallel cable. Please upgrade your programmer to USB model. Q: we are using Superpro III universal programmer. The adapter supplied with the unit is damaged. Kindly give the volt & Amp rating for the new adapter. A: Superpro III has two modules working on 28V and 12V respectively. Please check your programmer about the power input information and tell us which module you use. If necessary, you properly need to open the programmer. Q: I got the error message cannot found programmer when I installed Xeltek 9000U on my computer. A: Please be sure to insert a minimum of one CF
Related Questions
- I want to buy an interface card for Xeltek Superpro II programmer. Or could you send me the drawing if it is no longer available?
- If ESR positions are modelled around cost centres will this have to change in future to support the interface?
- Do you have an interface board for the superpro 40 pin programmer, and if so at what cost?
