Can print boundary be adjusted?
There is a Printer.ini file under GStarICAD catalog, in which record boundary, max/min line width, extended parameter and export catalog of virtual print. This file can be opened and edited by notepad. Margin is the space between print area and paper boundary, default value will be used if it was set as negative, and boundary can be change if positive. Please make sure the image is in gray print area. MinWidth is Minimum line width, if the set line width is smaller then min width, it will print as min width. You also can adjust the value if you feel it too small. Then it doesn’t need to reset if print as min width in color mapping. MaxWidth is Maximum line width, the default value is 10. You must adjust this value if the wanted value is bigger than 10. Offset Factor is pixel of offset, this value can be adjusted properly if it doesn’t print normally by snapping frame-select boundary of paper. It doesn’t need adjustment usually.
