Can ILLE be used for 50w AR111 as for 50w dichotic 75w and 100w?
What happens if I wire the output into the input side of ILLE? It doesn’t matter which way around ILLE is placed in the circuit, although the current model is marked with Input and Output. The new model will have a different plug on the input to the output, so that confusion will not occur What effect (if any) does Power Factor Correction Equipment have on the viability of using ILLE? Power factor correction equipment is typically installed within the main distribution board of a building. This equipment is used where it is deemed desirable to have the incoming voltage in phase with the incoming current. This outcome is normally achieved by switching capacitors across the incoming phases. (Automatically depending on the load of the building). Because buildings are inductive loads due to motors, fans, compressors, refrigeration, etc, capacitors are necessary to correct the power factor. These capacitors however have little effect on arresting down-stream voltage spikes which occur as th
