Can I use a remote control to control power on/off or volume on the PA 4000 via the optional IR sensor installed in a KP 1?
No. The optional IR sensor relays the remote control signal to a source device, such as a receiver or processor, or a DVD player. The PA 4000 itself can be controlled using the 3 buttons on the KP 1 keypad, or using the controls on the PA 4000’s front and rear panels. Alternatively, you could adjust the PA 4000’s Power Control Mode Switches to power each channel pair on using the Music Sense or AC/DC Trigger modes instead of via the keypad. In Music Sense mode, the PA 4000 will automatically turn on when an audio signal is present at the inputs, and will automatically turn off when no signal is present for approximately 10 or 15 minutes. In AC/DC Trigger mode the unit will automatically turn on when a 3 – 30-volt signal is applied to the Trigger Jack. In either of these modes, you could use the remote control to pass a power-on command to your source component via the optional IR sensor installed in the KP 1. In Music Sense mode, your source component will cause the PA 4000 to power on
Related Questions
- I have a power venter with CK-20 series control kit installed with a residential gas water heater. Why won the pilot light stay lit?
- Can I use a remote control to control power on/off or volume on the PA 4000 via the optional IR sensor installed in a KP 1?
- How do I use a video or power sensor for IR device feedback?
