Can I plug new fuses in with out any test?
Dom, from New York. It is standard procedure to test the airbag (restraint) system with a DRB scan tool after maintenance or repair. If the fuses are missing, that suggests that the system may not have been tested. I would contact the repair shop and verify exactly what was done, if they tested the system and what were the results. When maintenance is performed on the system, it is standard procedure to disconnect the negative battery cable (as part of the procedure) to disarm the restraint system; fuses are not normally removed. I would not attempt to install the fuses until I contacted the shop. If the airbag warning lamp either fails to light, or goes on and stays on, there is a system malfunction. 1434. I have a 2005 BEPT with 2500 miles. I purchased 4 chrome door lock pulls to “spruce up” the inside of my PT, but was not able to remove the existing gray pulls. I went to local dealer and they stated that they are almost certain the pulls are an integral part of the lock mechanism.
