Can i install the PD1 sensors or do i have to find a professional installer?
Any good DIYer can fit the PD1 sensors. The electrical connections are very simple and the only resistance you may find is removing the bumper but this is easier than it at first may seem. Removal of the bumper is not as difficult as it at first may seem and is typically held on with 2-4 main bolts and screws and some locators. In a few cases rivets are used that need to be popped out and simply replaced from your dealer parts department (at a minimal cost) when re-fitting. If required your dealer’s parts department can provide an exploded view (print off) of your front and rear bumper assembly and this will show you exactly how the bumper is fixed to your car or vehicle and where any screws, locators or rivets can be found. Alternatively a Haynes Manual will detail this information. If you choose a professional installation most auto electricians, car audio and security installers, mechanics and body shop technicians will remove the bumper literally in minutes. Post sale you will rece
