Can I install a TREMEC TKO into a 65-66 Mustang without cutting the floor to get the proper drive angle?
No, the TREMEC 3550 and TKO are much too tall in the main case and needs more room to achieve the correct drive angle. If the transmission is allowed to hang down, the case is exposed to road clearance hazards and will cause vibration, especially when decelerating. To properly install a TREMEC 3550 or TKO into a 65-66 mustang, the floor trans tunnel should be raised about 1.5. Top • Can a shifter be installed where the other two inspection covers are now? Yes, there are two kits available. Mid and front position. Note, the factory front shift is obsolete. We are working towards an aftermarket replacement.
Related Questions
- Can I install a TREMEC 3550 into a 65-66 Mustang without cutting the floor to get the proper drive angle?
- Can I install a TREMEC TKO into a 65-66 Mustang without cutting the floor to get the proper drive angle?
- Do I need to replace my drive shaft slip yoke when installing a T-5, Tremec 3550/TKO/TKO500/600?
