Can I customize the geocoding algorithm?
The automatic geocoding algorithm comes pre-configured with sensible settings that should suffice for common uses of HoudahGeo. HoudahGeo copies the below settings into your project documents. The settings may then be adjusted on a per project basis by selecting “Geocode from Tracks & Waypoints” from the “Geocode” menu.. The following should be read only by advanced users. For special needs, you might however want to fine-tune those settings. Currently this can only be done on the command line in Terminal.app. Please quit HoudahGeo before proceeding. Available settings are: – gobbingLimit: Number of minutes by which to extend the search for tracks matching a given photo. This defaults to 5 minutes. A photo is considered to match up with a track if it falls within the track’s time span of 5 minutes within the beginning or end of that time span. – mergingLimit: GPS devices may start new tracks when turned on or after losing GPS signal. Strictly speaking we cannot geocode a photo that fal
