Bradley 1771 Remote I/O Driver I get a message that “Card 5136-SD did not initialize properly” when I run PICS in a new computer under Windows 3.1. What do I do?
• Check if there is a memory conflict with other hardware or software. • Check the CMOS setup. In a computer with AMI Plug and Play BIOS, in the advanced setup section, you must set the ISA shared memory size to match the size of the area to be occupied by the card; for example, 32K. You must also set the ISA shared memory base address to match the memory address of the card; for example, D000. • Is the card is at the default memory address of D000? Check if you add x=D000-D7FF to the end of the line in your config.sys file that reads: DEVICE=C:\windows\EMM386.EXE x=D000-D7FF. For this example, add: EmmEclude=D000-D7FF in the [386Enh] section of the SYSTEM.INI file.
Related Questions
- Bradley 1771 Remote I/O Driver I get a message that "Card 5136-SD did not initialize properly" when I run PICS in a new computer under Windows 3.1. What do I do?
- I am using Windows XP with Service Pack 2 and keep getting a warning message when trying to run the Driver Agent. What can I do?
- What are the maximum number of console redirection sessions that I can run on a remote system?
