Are there special installation instructions, or break-in requirements?
A. Axxis brake pads exactly replace the original equipment pads your vehicle came with from the factory. The braking performance of our friction is superior to original equipment formulations. Here are our recommended Break-In Procedures: BREAK-IN PROCEDURES After installing new brakes, they need to be broken-in properly. To condition friction and rotors correctly, the following procedures should be followed: • Accelerate vehicle to 40 MPH. • Apply brakes using light to moderate pedal effort to reduce speed to approximately 10 MPH. • Repeat steps 1 and 2 at least ten times, allowing 1/4 mile between cycles. Under no circumstances drive the vehicle with the brakes continually applied as a break-in procedure because: • Excessive heat will be generated. • Resins will burn. • Loss of braking efficiency could occur.
