Are tapware installation intructions provided?
All tapware is to be installed by a qualified tradeperson (plumber) who would naturally be very familiar with the correct method of installing general tapware. Installation instructions for exposed sets are provided as a guide to the qualified tradesperson/installer who may be less familiar with this type of tapware.The Company accepts no responsibility for faulty installation but their trained personnel can provide advice by phone or fax if there are difficulties. Q Can a diverter unit (codes HE9481–2–3,RU9481–2–3, RL9481–2–3) be fitted in place of a standard three-piece bath set A Yes – there are two ways of doing it 1. Remove the bath set, including the in-wall plumbing and a few of the covering tiles, and start again with two water outlets. 2. Remove the exterior part of the bath set. Cap the central hole (where the bath spout was).Two fittings called ‘wobble joints’ must then be fitted along with 2 15 x 18 breeching piece nipples to the other two holes, and these convert the tap h
