Are Linksys Ethernet Bridges supported in a Cisco Wireless Unified Solution?
A. No, the WLC supports only Cisco WGB products. Linksys WGBs are not supported. Although the Cisco Wireless Unified Solution does not support the Linksys WET54G and WET11B Ethernet Bridges, you can use these devices in a Wireless Unified Solution configuration if you use these guidelines: • Connect only one device to the WET54G or WET11B. • Enable the MAC cloning feature on the WET54G or WET11B to clone the connected device. • Install the newest drivers and firmware on devices connected to the WET54G or WET11B. This guideline is especially important for JetDirect Printers because earlier firmware versions cause problems with DHCP. Note: Other third-party bridges are not supported. The steps mentioned can also be tried for other third-party bridges. Features FAQ Q. How do I set the Extensible Authentication Protocol (EAP) type on the Wireless LAN Controller (WLC)? I want to authenticate against an Access Control Server (ACS) appliance, and I get an “unsupported EAP” type in the logs. A
