Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

Are firmware jobs run by using both HTTP and SNMP?

April 26, 2017firmware http jobs run SNMP

0

Posted

Are firmware jobs run by using both HTTP and SNMP?

3 Answers

0

Posted

A. No. Firmware upgrades use SNMP only. Make sure the following setup parameters are in place before running the upgrade job: SNMP credentials for the device (with admin and firmware privileges on the AP) must match those entered on the WLSE SNMP device credentials screen.

0

Posted

A. Non-IOS firmware jobs use both HTTP and SNMP protocols. IOS firmware upgrades and conversion from non-IOS to IOS use SNMP only. •Non-IOS firmware upgrades: •HTTP is valid for all supported device versions. The following setup parameters must be in place for HTTP to function properly: HTTP credentials for the device (with admin and firmware privileges on the AP) must match those entered on the WLSE HTTP device credentials screen. TFTP server settings on the access point must reference the WLSE’s IP address.

0

Posted

A. Yes. Firmware jobs use both HTTP and SNMP protocols. •HTTP is valid for all supported device versions. The following setup parameters must be in place for HTTP to function properly: –HTTP credentials for the device (with admin and firmware privileges on the AP) must match those entered on the WLSE HTTP device credentials screen. –TFTP server settings on the access point must reference the WLSE’s IP address.