Are both radios powered-up and connected to their antennas?
3. No COM2 data transmission? a) The AP radio must direct data to the DG radio IP address and the DG radio must direct data to the AP radio IP address. [Main Menu > Serial Gateway Configuration Wizard > COM2] b) Verify baud rate (factory default is 9600). c) Verify data format (factory default is 8N1). d) Verify flow control setting (factory default is DISABLED). e) Verify COM2 LED lights when RS-232 data is being sent or received via that radio’s DB-9 port or the distant radio’s DB-9 port; null modem cables with DB-9F connectors may be required. f) If using Burk equipment and cable assemblies with DB-9F to 2 BNC connectors, try reversing “IN”/”OUT”, “Tx”/”Rx” data connections; verify the Burk baud rate (minimum 1200 baud to use the Lanlink). g) If either radio is power-cycled while the COM2 port is receiving continuous data, some radios will not restore data flow until COM2 is unplugged then plugged back in. Fixes are available for this known bug – please contact the Moseley factory f
