After few minutes, the HDD LED is still blinking and I can make selections ?
When the hard disk player is powered up, diagnostics are performed followed by a disk file scan. If an error is found, the LED will blink out the code number. Count the “on” blinks to determine the code (1 to 4 blinks). (1) INITIALIZATION ERROR, disk drive is not inserted correctly or MP3 player board failure. (2) FILESYSTEM ERROR, unable to locate FAT32 filesystem or drive was not formatted. (3) NO FOLDERS FOUND, a directory folder is used for each CD, check disk contents. (4) NO MP3 FILES FOUND, MP3 files are used for each audio track, check disk contents. Wireless Remote Control When I press the V- or V+ button on the remote, the receiver LED does not light ? When power is applied to receiver unit, the LED will light for a few seconds then go out. This is to let you know that the receiver is working and ready. When you press V- or V+ the LED at the receiver unit should light. If the receiver LED does not light, the remote control needs to be programmed. You will use the CANCEL butto
