DynSite does not detect when my external IP address changes. How often does it poll for changes?
If you configured a permanent connection in Setup > Connections tab, DynSite polls for IP changes every 10 minutes by default. This default value avoids the flooding of the servers used for auto-detection. For the same reason, 10 minutes are the lower interval if you use auto-detection. If you use your router for IP address detection, you can set an interval as low as you wish. To change the polling interval, go to Setup > Connections tab > click your network card > click Configure… > click the Options tab. Important notice to Windows 2000 users: either install the Service Pack 3 (or later) or install the fix described in Knowledge Base article Q322913. If this patch is not installed, this may prevent DynSite from correctly monitoring your connection.
Related Questions
- I configured DynSite V1.11 to get the external IP address from the status page of my router but it gets the IP address of the DNS server, what can I do?
- Id like to configure DynSite so that it pulls my external IP address from my router (instead of a remote website), how do I do that?
- DynSite does not detect when my external IP address changes. How often does it poll for changes?
