How do I control the router bandwidth?
If you are a network administrator or in charge of your company’s network, there are times that your network may be getting a lot of network traffic hits. To prevent overloading of your network and to remove unwanted or unnecessary traffic, you can perform a process that would limit the rate of network traffic, also known as Committed Access Rate (CAR). You can effectively manage your network by ensuring that the inbound unwanted traffic will not impact the important traffic from getting through. As a requirement, you should be familiar with basic Cisco networking commands to be able to do this function, as well as be familiar with networking in general. To limit the band wtdth you ned to use the cisco router……. So please Just follow the steps listed below: Step 1 Enable CEF (Cisco Express Forwarding) on the Cisco router. Most routers have CEF disabled by default except on the 7 series routers. The codes to enter the commands on the global configuration mode are as follows: Router#
