Who uses Remzibis OSD?
People from all over the globe are using Remzibi’s OSD. Take a look at the list of countries! Getting StartedBack to Table of Contents Wiring up Remzibi’s OSD board Photo of v.1 style board Two battery (v.1 style board – 2 video grounds) Photo of v1.1 style board Two battery (v1.1 style board – 1 video ground) To get your OSD board up and running, you will need the following: 1) R/C Plane well suited for FPV (ie Brushless EasyStar). 2) Video Transmitter and Receiver (ie 900Mhz 500mw system). 3) Video camera (ie KX-131, KX-171 or KX-191). 4) Video goggles or DVR for viewing/recording (ie FatShark or R-Vision Goggles). 5) Remzibi’s OSD!!! The OSD board is placed between the video camera and the video transmitter on the R/C plane. There are typically 3 wires that connect these two components. A red wire (power either 5V or 12V), a black wire which is ground and a white wire which is the video signal. You will need to make a custom cable to go from the video camera to the OSD and out of th
