How Do You Make A Fat Origami Rabbit?
• Get a piece of origami paper or cut a piece of printer or construction paper into a 5 inch by 5 inch (13cm) square. Lay your paper down on a flat surface. If you have two-colored paper, the side facing down will be the outside of the rabbit. • Fold the paper diagonally. • Crease the paper well, and then unfold it. • Fold the paper diagonally again, but this time the other way. • Crease the paper well, and unfold. • Fold the paper horizontally • Crease and unfold. Turn the paper sideways. • Push the paper down in the middle, and pull the sides up a little so they’re popping out a little. • Make the sides touch, and push down on the top. • Fold the edges of the first layer up to make a diamond. • Take the sides of the diamond and fold them in so that the points are touching the center of the diamond. • This is a bit tricky. Take the triangles and push a bit on the side so there’s a little “pocket”. Then, take the top of the diamond and put it in the “pocket”. Do this to both sides. • F
