Wind Controller Composite Patchman Music How do I adjust the WIND GAIN and WIND ZERO sensor on my WX5?
The breath sensor is adjusted by carefully adjusting the WIND GAIN and WIND ZERO trimmers located on the bottom of the WX5 under the removable rubber plugs. It helps to have a VL70-m with its wonderful BC display meter in the LCD or a MIDI monitor utility such as MidiOx to see what is happening. WIND ZERO = Sets the threshold or turn on point. This sets the threshold point where the note is sent from the WX5. WIND GAIN = Sets the sensitivity of the breath sensor. This adjusts how hard you have to blow to get to full level. These trimmers are located under small rubber plugs. Remove these plugs to adjust then be sure to replace them when done to keep water out of the sensitive electronics. In adjusting these trimmers, you use a small flat head screwdriver. IMPORTANT: The internal trimmers are made of plastic. They turn only about 270 degrees. They do not turn all the way around. Use great care not to turn them past the point where they stop. If you strip them out or break them, the repa
Related Questions
- Wind Controller Composite Patchman Music I am having trouble accessing the Performance Bank on my Roland JV-1010. Any suggestions?
- Wind Controller Composite Patchman Music How do I adjust the WIND GAIN and WIND ZERO sensor on my WX5?
- Wind Controller Composite Patchman Music What are the differences between the Yamaha WX7, WX11, and WX5?
